6.2.10 Uncoupling the machine
For tractors not fitted with a hydraulic
position control function, unhook and attach
check chain to its support.
Always park the machine with the cutter bar
in horizontal position.
- Place the cutterbar in horizontal position.
- Pull on handle (1) to unlock parking stand (2) (a).
- Lower and lock parking stand (b).
- Lower the tractor three-point linkage to rest the
machine on the ground.
- Uncouple the PTO shaft.
- Support PTO shaft with check chain attached
around the hitch pin.
When optional equipment is used, follow
specific procedures mentioned in the related
section:
• Optional
hydraulic cutter bar lift pump.
- Disconnect and store hydraulic hose in holder (3).
- Remove cord from tractor and store it in its holder
on the machine.
- Detach the top link from the machine end.
- Release the lower links.
When optional equipment is used, follow
specific procedures mentioned in the related
section:
• Optional equipment / Lighting and
signalling.
The machine is uncoupled.
50
6. - Putting into service
equipment
/
Manual
Disc mower
GMD16-GMD20
3
2
1
a
b
KN225BGB_A