Declaration Of Incorporation - GEM 613 Installation, Operating And Maintenance Instructions

22

Declaration of incorporation

Declaration of Incorporation
according to the EC Machinery Directive 2006/42/EC, Annex II, 1.B
Manufacturer:
Description and identification of the partly completed machinery:
Make:
Serial number:
Project number:
Commercial name:
We hereby declare that the following essential requirements of the Machinery Directive 2006/42/EC
have been fulfilled:
1.1.7.; 1.2.1.; 1.3.4.; 1.3.7.; 1.5.1.; 1.5.16.; 1.5.2.; 1.5.5.; 1.5.6.; 1.5.7.; 1.5.8.; 1.6.3.; 3.2.1.; 4.3.3.; 5.3.; 5.4.;
6.4.3.
We also declare that the specific technical documentation has been compiled in accordance with
part B of Annex VII.
We expressly declare that the partly completed machinery complies with the relevant provisions of
the following EC directives:
2006/42/EC:2006-05-17:
The manufacturer or his authorised representative undertake to transmit, in response to a reasoned request
by the national authorities, relevant information on the partly completed machinery. This transmission takes
place:
electronically
This does not affect the intellectual property rights!
Important note! The partly completed machinery may be put into service only if it was determined,
where appropriate, that the machinery into which the partly completed machinery is to be installed
meets the provisions of this Directive.
Joachim Brien
Head of Technical Department
Ingelfingen-Criesbach, January 2014
613, 618
for partly completed machinery
GEMÜ Gebr. Müller Apparatebau GmbH & Co. KG
Postfach 30
Fritz-Müller-Straße 6-8
D-74653 Ingelfingen-Criesbach
GEMÜ Diaphragm valve, motorized and linear actuator, motorized
from December 29, 2009
Hubantrieb-Typ 9618-2013-11
Type 613, Type 618, Type 9618
(Machinery Directive) Directive 2006/42/EC of the European Parliament
and of the Council of 17 May 2006 on machinery, and amending Directive
95/16/EC (recast) (1)
58 / 64