CipherLab 8 Series User Manual page 251

OFF_TCPIP
OFF_TIMER(N%)
OFF_TOUCHSCREEN
ON_COM(N1%,N2%)
ON_ESC(N%)
ON_GOSUB(N%)
ON_GOTO(N%)
ON_HOUR_SHARP(N%)
ON_KEY(N%)
ON_MINUTE_SHARP(N%)
ON_POWER_ON(N%)
ON_READER(N1%,N2%)
ON_TCPIP(N%)
ON_TIMER(N1%,N2%)
ON_TOUCHSCREEN(N%)
OPEN_COM(N%)
OR
POWER_ON(N%)
PRINT(A$)
PUT_PIXEL(...)
PUTKEY(N%)
RAM_SIZE
READ_COM$(N%)
READER_CONFIG
READER_SETTING(N1%,N2%)
Indicating the command OFF TCPIN is processed.
Indicating the command OFF TIMER is processed. N% is the
number of the timer.
Indicating the command OFF TOUCHSCREEN is processed.
Indicating the command ON COM GOSUB is called. N1% is the
umber of the COM port; N2% is the line number of the
subroutine to branch to.
Indicating the command ON ESC GOSUB is called. N% is the line
number of the subroutine to branch to.
Indicating the command ON GOSUB is called. N% is the line
number of the subroutine to branch to.
Indicating the command ON GOTO is called. N% is the line
number of the subroutine to branch to.
Indicating the command ON HOUR_SHARP GOSUB is called. N%
is the line number of the subroutine to branch to.
Indicating the command ON KEY GOSUB is called. N% is the line
number of the subroutine to branch to.
Indicating the command ON MINUTE_SHARP GOSUB is called.
N% is the line number of the subroutine to branch to.
Indicating the command ON POWER_ON GOSUB is called. N% is
the line number of the subroutine to branch to.
Indicating the command ON READER GOSUB is called. N1% is
the number of the reader port; N2% is the line number of the
subroutine to branch to.
Indicating the command ON TCPIP GOSUB is called. N% is the
line number of the subroutine to branch to.
Indicating the command ON TIMER GOSUB is called.
Indicating the command ON TOUCHSCREEN GOSUB is called.
N% is the line number of the subroutine to branch to.
Indicating the command OPEN_COM is processed. N% is the
number of the COM port.
Indicating the logical operation OR is processed.
Indicating the command POWER_ON is processed. N% is the
value of the setting.
Indicating the command PRINT is processed.
Indicating the command PUT_PIXEL is processed.
Indicating the command PUTKEY is processed.
Indicating the command RAM_SIZE is processed.
Indicating the command READ_COM$ is processed. N% is the
number of the COM port.
Indicating the command READER_CONFIG is processed.
Indicating the command READER_SETTING is processed. N1% is
the setting number; N2% is the value of the setting.
Appendix V Debugging Commands
239