Keyboard Wedge Commands - CipherLab 8 Series User Manual

4.9 KEYBOARD WEDGE COMMANDS

For 8300 Series, it can be programmed to send data to the host through the physical
wedge interface by using the SEND_WEDGE(). For those that do not allow the keyboard
wedge cable, alternatives are Bluetooth HID, USB HID and the Wedge Emulator utility.
Refer to the table below,
Wedge Options
Keyboard Wedge Cable
Wedge Emulator via IR, IrDA, RS-232
Wedge Emulator via Bluetooth SPP
Bluetooth HID or USB HID
SEND_WEDGE() is governed by a set of parameters called WedgeSetting$. The
command SET_WEDGE is used to configure these parameters.
Emulator, and Part II: Appendix IV Examples.
4.9.3 Wedge
Related Functions
SET_WEDGE
SEND_WEDGE
WEDGE_READY
SEND_WEDGE
WEDGE_READY
OPEN_COM
SET_COM
SET_COM_TYPE
CLOSE_COM
SEND_WEDGE
WEDGE_READY
OPEN_COM
SET_COM
SET_COM_TYPE
CLOSE_COM
SET_WEDGE
OPEN_COM
SET_COM
SET_COM_TYPE
CLOSE_COM
GET_NET_STATUS
WRITE_COM
Chapter 4 BASIC Commands
Supported by
8300 Series
8000/8300/8500 Series
8000/8300/8500 Series
8000/8200/8300/8400/8500/8700
Series
93