Download Print this page

CipherLab 8000 Quick Start Manual

Hide thumbs Also See for 8000:

Download this manual

Configure UPC Scan Settings In CipherLab 8000

This document is for anyone who scans an item and receives (item not

found) do to the CipherLab not looking at the last digit (Check Digit) or the

first digit (Leading Digit) of the UPC.

Leading Digit

Check Digit

Need help?

Do you have a question about the 8000 and is the answer not in the manual?

Page 1 Configure UPC Scan Settings In CipherLab 8000 This document is for anyone who scans an item and receives (item not found) do to the CipherLab not looking at the last digit (Check Digit) or the first digit (Leading Digit) of the UPC.
Page 2  Power on the device and walk through the configurations matching the grid below until you get to the (Drop UPC Options).  At the (Drop UPC Options), tap the dot above the 3 on the device to change the values between Y & N as shown below. The check digit (UPCE Last) is set to yes meaning that it will be dropped from the UPC when the item is scanned.
Page 3  This configuration will remove the leading digit from the UPC when an item is scanned.  The configuration below will remove both the leading digit and check digit from the UPC when an item is scanned.
Page 4  Leaving all options set to N (Default Setting) will scan the entire UPC including both the leading digit and check digit.  Once you have configured how you want your UPC’s scanned, finish the rest of the setup following the setup grid.