Start-Up; Safety; Remarks On The Cooling Unit; General - Fronius MagicWave 190 Operating Instructions Manual

Start-up

Safety

An electric shock can be fatal.
If the device is plugged into the mains during installation, there is a high risk of very serious
injury and damage.
► Only carry out work on the device if the mains switch is in the "O" position.
► Only carry out work on the charger when it has been disconnected from the mains sup-
Remarks on the The TT / MW 230i power sources can be operated with a cooling unit.
cooling unit A cooling unit is recommended for the following applications:
-
-
-
The cooling unit is powered from the power source. The cooling unit is ready for operation
when the mains switch of the power source is in the "I" position.
More information on the cooling unit can be found in the Operating Instructions for the cool-
ing unit.

General

This section describes how to commission the power source:
-
-
The standard configuration consists of the following system components:
-
-
-
-
-
-
-
The steps set out below provide an overview of how to commission the power source.
For detailed information about the individual steps, please refer to the operating instruc-
tions for the system components.
WARNING!
ply.
Hosepacks over 5 m long
TIG AC welding
In general, where welding is performed in higher power ranges
for the main TIG welding application
with reference to a standard configuration for a TIG welding device.
power source
cooling unit
TIG manual welding torch
pressure regulator
gas cylinder
gas cylinder holder
trolley
41