Care, Maintenance And Disposal; Safety; General; Maintenance At Every Start-Up - Fronius TransPocket 150 Operating Instructions Manual

Care, maintenance and disposal

Safety

Danger due to incorrect operation and incorrectly performed work.
This can result in serious injury and damage to property.
▶
▶
▶
Danger from electric current.
This can result in serious injury or death.
▶
▶
▶
Electrical current hazard caused by an inadequate ground conductor connection.
This can result in serious injury and damage to property.
▶

General

Under normal operating conditions, the device requires only a minimum of care and
maintenance. However, it is vital to observe some important points to ensure the device
remains in a usable condition for many years.
Maintenance at -
every start-up
-
-
-

Every 2 months

Clean air filter:
WARNING!
All the work and functions described in this document must only be carried out by
trained and qualified personnel.
Read and understand this document.
Read and understand all the Operating Instructions for the system components,
especially the safety rules.
WARNING!
Turn the mains switch of the power source to the "O" position and disconnect the
power source from the mains supply.
Secure all the devices and components involved to prevent unintentional restarting.
After opening the device, use a suitable measuring instrument to check that electric-
ally charged components (such as capacitors) have been discharged.
WARNING!
Always use the original housing screws in the original quantity.
Ensure that the mains plug and mains cable as well as the welding torch / electrode
holder are undamaged. Replace any damaged components
Ensure that the welding torch / electrode holder and the grounding cable are prop-
erly connected to the power source and screwed/locked in place as described in this
document
Ensure that a proper ground earth connection has been established to the work-
piece
Check that there is an all-round clearance of 0.5 m (1 ft. 8 in.) around the device to
ensure that cooling air can flow and escape unhindered. Air inlets and outlets must
never be covered, not even partially.
41