Figure 5-2: Dc Power Cable Wiring; Figure 5-3: Omg Rear Panel Ports - Sierra Wireless oMG 2000 Quick Setup Manual

3. Wire the cable-end of the DC power cable into the vehicle's electrical system.

Figure 5-2: DC Power Cable Wiring

4. Attach the following cables to the ports on the rear of the oMG as shown in
a. Attach Ethernet cables from client devices to ETH ports 1, 2, and 3 (if used).
b. Attach Wi-Fi WAN antennas (2.4–6 GHz) to WAN3-A and WAN3-B.
c. Attach the Wi-Fi LAN antenna(s) (2.4–6 GHz):
·
·
d. Attach the GPS antenna to the GPS connector.
e. Attach the LTE WAN antennas (694–894 MHz and 1700–2700Mhz) to WAN1-A and
WAN1-B.
f. If your unit was ordered with the dual embedded cellular WAN radio option, attach a
second set of LTE WAN antennas (694–894 MHz and 1700–2700Mhz) to WAN2-A and
WAN2-B.
g. With ignition OFF (or AC POWER UNPLUGGED if using adapter), attach the power cable
connector to the power socket.
Warning:
Do not power down without following proper procedures (see

Figure 5-3: oMG Rear Panel Ports

Rev 1 Jul.16
If using two antennas (MIMO)—Connect to the LAN1-A and LAN1-B connectors.
If using one antenna (not MIMO)—Connect to the LAN1-A connector.
LTE WAN
LTE WAN Ethernet Ports 1-3
(Dual WAN)
Wi-Fi WAN
11
Install the oMG
Figure 5-3
Chapter 9 on page 15).
GPS
Wi-Fi LAN
(Use LAN1-B only
if using 2 antennas)
4119612
below:
Power
Socket