Project 7 - The First Show Should Fade Out, If The Second Switch Is Triggered - WEIGL ProCommander LTC Instruction Manual

Control.ini
9.2.7 Project 7 – The first show should fade out, if
the second switch is triggered
The project consists of two shows.
The first show consists of an audio file and controls eight
PWM and 512 DMX channels. The show should fade out
smoothly, if the second switch is triggered. The audio should
fade out within two, the PWM channels within five and the
DMX channels within ten seconds. Therefore the following
commands have to be included in the command channel in the
second show.
At time zero the command !cfm0<2# (The volume of the
audio fades within two second to 0) has to be included.
At time two seconds the command !rse1# has to be included,
that the first show stops and don't interfere with the following
commands.
Shortly after two seconds the commands !epf1_8%0<5#
(Fade PWM channel 1 to 8 within five seconds to 0) and
!edf1_512:0<10# (Fade DMX channel 1 to 512 within ten
seconds to 0) have to be included.
After 12 seconds the new audio file and the new values of
DMX, analog and PWM channels can be adjusted as needed to
start a new show.
88
The content of the Control.ini file looks like this:
!i1c!rsn1#
!i2c!rsa2#