Procommander ® Ltc Configuration; Usb Port Configuration; Configuration Via Configurator - WEIGL ProCommander LTC Instruction Manual

6 ProCommander
In addition to the settings of the menu you can program the
ProCommander
®
if you want to change settings via network, USB or commands
from a microSD card while operating.
6.1

USB port configuration

You can configure the ProCommander
a terminal program, if the USB driver for the ProCommander
LTC is correctly installed on your PC, a COM
activated when you connect them. If your driver is not already
installed, Windows will prompt you when you connect it to.
Further information you find under
Now that you have started your terminal program and chosen
the activated COM
with the ASCII command !?#. To control the ProCommander
LTC through a LAN-network the
to be configured.
The required ASCII commands can be found here
6.2

Configuration via configurator

The ProCommander
both through USB and LAN-interface, with the help of the
configurator. Connect the device through USB- or LAN-wire
with your computer. You can download the configurator from
our website under "downloads".
You do not have to install the program. Copy the file from
the zip-archive into a new folder and start Weigl_Configurator.
Configuration ProCommander LTC
LTC configuration
®
LTC via ASCII commands. This is very useful,
port you can request the current settings
IP address
LTC can be configured easily,
®
LTC via USB through
®
port
"USB – driver installation".
and the
ASCII
®
will be
55
®
port have
chart.