Procommander Ltc Configuration; Usb Port Configuration; Configuration Via Configurator - WEIGL ProCommander LTC Instruction Manual

Hide thumbs Also See for ProCommander LTC:

Table of Contents

6 ProCommander LTC configuration

Additionally to the settings of the menu you can program the

ProCommander LTC via ASCII commands. This is very useful, if

you want to change settings via network, USB or commands

from a microSD card while operating.

You can configure the ProCommander LTC via USB through a

terminal program, if the USB driver for the ProCommander LTC is

correctly installed on your PC, a COM port will be activated when

you connect them. If your driver is not already installed,

Windows will prompt you when you connect it to. Further

information you find under 4 USB – driver installation.

Now that you have started your terminal program and chosen

the activated COM port you can request the current settings

with the ASCII command !?#. To control the ProCommander LTC

through a LAN-network the

configured.

The required ASCII commands can be found here ASCII-chart.

The ProCommander LTC can be configured easily, both

through USB and LAN-interface, with the help of the

configurator. Connect the device through USB- or LAN-wire with

your computer. You can download the configurator from the

Weigl-EM website.

ProCommander LTC configuration

IP address

and the

port

have to be

Table of Contents

Procommander 2