Craftex CX Series User Manual page 11

Figure-6 Adjusting the set screws
It is important to use a straight edge at
this time as a guide and the set screws for
leveling to make sure it is attached
properly. Position the extension wings
even with the main bed and once fully
leveled, tighten all hex bolts. See Figure-
7.
Figure-7 Leveling wings using straight edge
Repeat the same procedure for the other
extension wing.
The magnetic switch is in a protective
brown box. Remove the packaging of the
magnetic switch and attach it to the switch
bracket located on the left front of the
machine. Using the two screws and
washers provided, tighten the magnetic
switch in place. See Figure-8.
Figure-8 Installing the magnetic switch
Attach the dust hood to the top of the
planer first by using the hex bolts, flat
washers and hex nuts provided. Then
attach the bottom of the dust hood to the
planer in the same manner. See Figure-9.
Figure-9 Attaching the dust hood
Locate the hand wheel shaft on the right
side of the machine,
magnetic switch. Remove the screw and
washer off the keyway shaft and set them
aside. Place the hand wheel onto the
keyway shaft and put the screw and
opposite the
11