Attach Optional Mid-Level Spreader Flowtech 100; Operation Of Mid-Level Spreader Flowtech 100 - Vinten V4160-0001 User Manual

Installation

Attach Optional Mid-Level Spreader flowtech 100

CAUTION! Ensure the latching pins are fully engaged with
!
the locating holes in the tripod. Failure to attach correctly
could result in damage to the equipment
The tripod is delivered with the Hinge Lock in the OFF
position for use with a spreader.
(See page 14 for lock operation).
1.
Hold the spreader between thumb
and forefinger and squeeze the
release buttons on each side.
2.
Align the latching pins with the locating
holes on the tripod leg.
3.
Release the buttons to lock the
spreader in place.
8
Operation of Mid-Level Spreader
1.
Press and hold the arm release button (as below).
2.
Extend the inner arm to the required length and release the
button.
Visual Distance Markers
NOTE! The inner arm should not be pushed back against
the ratchet mechanism, always hold the release button
down whilst extending or retracting the inner arm.
The inner section has three distance markers (as shown above), this
helps to visually set the length of the spreader arms.
If the spreader will not go into the desired position, check
the tripod Hinge Lock is in the OFF (spreader mode)
position for use with a spreader. (See page 14 for lock
operation).
flowtech 100