Save Parameter Set; How To Proceed - Lenze 9300 Series Operator's Manual

2.2.3
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - e.mail: info@ctiautomation.net

Save parameter set

The parameters must be saved so that the changed settings do not get lost after mains
disconnection.
•
You can establish up to four parameter sets, e.g. if you process different materials on a
machine or if this is required by different operating states (setup mode, "stand-by").
•
If you need only one parameter set, save the modifications permanently under parameter set
1, since the controller automatically loads parameter set 1 after mains connection.

How to proceed

1. Change from the menus to the code level using the arrow keys.
"Code" is displayed.
2. Select C0810/1 using
3. Change to the parameter level using PRG.
"Para" is displayed.
4. Select C0810/1 using
Note: If the parameter set is to be saved under another number, select 2, 3, or 4 instead of 1.
5. Press SHIFT + PRG.
"OK" is indicated for approx. 1 s.
Now your settings are saved permanently under parameter set 1 (or 2, 3, 4).
Parameter setting using the keypad
or C0003.
Y B
or parameter on 1 (also possible at travelling drive).
Y B
Parameter setting