Operating Level - Lenze 9300 Series Operator's Manual

CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - e.mail: info@ctiautomation.net

Operating level

From the parameter level, you reach the operating level by pressing PRG.
•
In the operating level, additional status information and the additional display value specified
under C0004 is displayed (presetting: actual speed C0051).
– When the USER menu has been selected, the first code level of the USER menu will be
displayed in the first line.
•
Additional information is displayed according to the following priority list:
Priority Display
1 GLOBAL DRIVE INIT
2 XXX - TRIP
3 XXX - MESSAGE
4
Special controller states:
5
Source for controller inhibit (the value of C0004 is displayed at the same time):
STP1
STP3
STP4
STP5
STP6
j6
Source of quick stop:
QSP-term-Ext
QSP-C0135
QSP-AIF
QSP-CAN
7 XXX - WARNING
8 xxxx
User menu
In some applications, specific codes must be changed often.
You can therefore establish a menu with max. 32 codes which you use frequently under C0517.
•
The number before the comma is the code number.
•
The number after the comma is the subcode.
•
Code-subcode combinations are allowed only once.
Parameter setting using the keypad
Meaning
Initialisation or communication error between keypad and controller
active TRIP (contents of C0168/1)
active message (contents of C0168/1)
Switch-on inhibit
Terminal X5/28
Keypad or LECOM A/B/LI
InterBus-S or Profibus
System bus (CAN)
C0040
HIGH signal is applied at input MCTRL-QSP on the function block MCTRL
(in factory setting applied to terminals X5/E1 and X5/E2)
Keypad or LECOM A/B/LI
InterBus-S or Profibus
System bus (CAN)
active warning (contents of C0168/1)
Value under C0004
Parameter setting