Mounting The Engine - Seagull Models SEA FURY Assembly Manual

SEA FURY.

MOUNTING THE ENGINE.

1) Install the pushrod housing through the
predrilled hole in the firewall and into the servo
compartment. The pushrod housing should
protrude 1/4" out past the front of the firewall.
Make a Z-Bend 1/4" from one end of the plain
wire pushrod.
150mm.
2) Place your engine onto the engine
mount. Adjust the engine is centered of the
edges of the engine case.
3) When you are satisfied with the align-
ment, mark the locations of the engine
mounting.
4) Remove the engine. Using an drill bit,
drill the mounting holes through the engine
mount at the four locations marked.
4 x 30mm.
4.2mm.
Bolt the engine to the engine mount
5)
using the four machine screws. Double
cheek that all the screws are tight before
proceeding.
6) Attach the Z-Bend in the pushrod wire
to the throttle arm on the carburetor.
Instruction Manual.
Engine 2 stroke.
Machine Screw 4x30mm.
Pushrod wire.
Engine 4 stroke.
Machine Screw 4x30mm.
COWLING.
1) Slide the fiberglass cowl over the en-
gine and line up the back edge of the cowl with
the marks you made on the fuselage.
Pushrod wire.
Trim and cut.
15