Table of Contents
Advertisement
SEA FURY.
1) Elevator and rudder pushrods assembly follow pictures below.
M2 clevis.
Attach to servo arm in fuselage.
control horn.
Elevator Pushrod.
Metal clevis.
2) Connect the elevator and rudder servos
to your radio's receiver and turn on the sys-
tem. Set the trim tabs on the transmitter to
neutral and center the servo arms. The eleva-
tor and rudder servo arms should be perpen-
dicular to the servos.
3) One at a time, hold the pushrods in po-
sition over the respective servos to check for
proper servo direction. If any servo turns in
the wrong direction, switch your radio's re-
versing switches as necessary to achieve the
correct direction.
Elevator pushrod.
Rudder pushrod.
20
RUDDER PUSHROD INSTALLATION.
position of the servo arms on the servos. See
picture below.
Instruction Manual.
M2 Lock nut.
Attach to elevator - rudder control horn.
Rudder pushrod.
Elevator pushrod.
4) Install servos arm to servos. Notice the
Throttle.
Rudder.
SERVO ARM THROTTLE.
Adjustable Servo connector.
Nut.
Thread locker glue.
Elevator pushrod.
Elevator.
Elevator.
Servo arm.
Advertisement
Table of Contents
