Fukuda FL-601 Series Operational Manual page 79

MAINTENANCE FUNCTIONS
5. Press the ENT key. The LCD will display screen 1/3. (REMOTE Input/Output signal)
The ◆ will light up when signals are being input from an external source.
6. Press the key. The screen will display screen 2/3. (REMOTE Output Signal)
The * mark will be on OK
7. Pressing the ENT key will display a ◆ sign next to the OK label, and output an OK signal
from the corresponding pin of the REMOTE terminal.
Other signals can be output from the corresponding pin of the REMOTE terminal in the
same way by using the
and pressing ENT. (The ◆ sign is then displayed next to the corresponding signal).
8. Press the
signal)
The * mark will be next to SV1
9. Press the ENT key. The SV1 signal will be output.
Other signals can be output in the same way by using the
* mark to the desired signal and pressing the ENT key.
78
I/O CHECK FUNCTION
I/Ocheck
◆
stop
start
fitting
bubl
retry
I/Ocheck
＊
OK
+NG
-NG
NG2
BNG
key. The screen will display screen 3/3. (EXH VALVE SIGNAL output
I/Ocheck
＊ SV1
SV2
SV3
SV4
SV5
1/3 INPUT
gp1 Psw
gp2 ENG
gp4 LM1
gp8 LM2
cal
2/3 OUTPUT
PNG NC
RUN M/R
RDY
END
ERR
cursor to move the * mark to the desired signal
3/3 OUTPUT
SV6
SV7
SV8
cursor to move the