Fukuda FL-601 Series Operational Manual page 32

○ CONTROL KEYS
BUBL (Retained charging)
Used when conducting air
bubble testing.
SET (Setting)
Used to input
setting values.
GROUP
Used to change group
settings.
*When you push this button on
the regular screen, the Group
No. value (in the lower right
portion of the screen) will blink.
While it is blinking, you can use
the up and down arrows to
change the group.
ARROW KEYS
To change the position of
the cursor during
value input.
FITTING(
Fitting)
Used when conducting
Fitting testing.
START (Execution)
Press this key in order to
conduct actual standard
testing.
SUPPLEMENT: Note to use REMOTE（external）mode
When used in REMOTE (external) mode, internal settings functions
(and maintenance, etc.) will not work until the unit is switched back to
MANUAL (Internal). After completing these internal functions, make
sure to switch back to REMOTE (External) mode and press the ENT
key.
POWER ON PROCEDURE THE NAMES OF EACH PART
MAINT
(Maintenance)
Confirms status
problems occur
Used to measure volume.
MANUAL
(Internal)
REMOTE
(External)
Can select manual
.
remote control
*After selecting, press ENT
to store your selection.
Even if the power is shut
off, the tester can resume
using this stored value.
(Refer to supplement.)
ENT Enter
Press enter to activate the
input value.
STOP
Used to suspend operation.
*If this key is pressed while
inputting settings (instead
of ENT), the setting value
will not be stored into the
system.
Be sure to press ENTER to
store the setting value.
when
or
31