Lexus LS 500h 2019 Owner's Manual page 451

HomeLink
then release it.
 If the garage door or other device
does not operate, proceed to "Pro-
gramming a rolling code system".
5 Repeat the steps above to program
another device for any of the
remaining HomeLink
Programming a rolling code sys-
■
tem
2 or more people may be necessary to
complete rolling code programming.
Locate the "Learn" or "Smart" but-
1
ton on the garage door opener
motor in the garage.
This button can usually be found where the
hanging antenna wire is attached to the
unit. The name and color of the button may
vary by manufacturer. Refer to the owner's
manual supplied with the garage door
opener motor for details.
2 Press and release the "Learn" or
"Smart" button.
Perform 3
LS500h_OM_General_OM50J66E
®
button for 2 seconds
®
buttons.
within 30 seconds after per-
5-6. Using the other interior features
forming 2.
3 Press and hold the desired
®
HomeLink button (inside the
vehicle) for 2 seconds and release
it. Repeat this sequence
(press/hold/release) up to 3 times
to complete programming.
If the garage door opener motor
operates when the HomeLink
button is pressed, the garage door
opener motor recognizes the
®
HomeLink signal.
Enabling 2-way communication
■
with a garage door (only available
for compatible devices)
When enabled, 2-way communication
allows you to check the status of the
opening and closing of a garage door
through indicators in your vehicle.
2-way communication is only available
449
®
5