Table of Contents
Advertisement
330
4-5. Using the driving support systems
switch is released becomes the set speed.
Adjusting the set speed
To change the set speed, press the
"+RES" or "-SET" switch until the
desired set speed is displayed.
Increases the speed
1
2
Decreases the speed
Fine adjustment: Press the switch.
Large adjustment: Press and hold the
switch to change the speed, and
release when the desired speed is
reached.
In the vehicle-to-vehicle distance con-
trol mode, the set speed will be
increased or decreased as follows:
Fine adjustment: By 1 km/h (0.6 mph)
1mph (1.6 km/h)
pressed
Large adjustment: Increases or decreases
LS500h_OM_General_OM50J66E
*1
or
*2
each time the switch is
*1
in 5 km/h (3.1 mph)
or 5 mph (8
*2
km/h)
increments for as long as the
switch is held
In the constant speed control mode
(P.332), the set speed will be
increased or decreased as follows:
Fine adjustment: By 1 km/h (0.6 mph)
*2
mph (1.6 km/h)
each time the switch is
pressed
Large adjustment: The speed will continue
to change while the switch is held.
*1
: When the set speed is shown in "km/h"
*2
: When the set speed is shown in "MPH"
Changing the vehicle-to-vehicle
distance (vehicle-to-vehicle dis-
tance control mode)
Pressing the switch changes the vehi-
cle-to-vehicle distance as follows:
1
Long
2
Medium
3
Short
The vehicle-to-vehicle distance is set auto-
matically to long mode when the power
switch is turned ON mode.
If a vehicle is running ahead of you, the
preceding vehicle mark
A
displayed.
*1
or 1
will also be
Advertisement
Table of Contents
