Table of Contents
Advertisement
272
4-5. Using the driving support systems
If a warning message is displayed on the multi-information display
■
A system may be temporarily unavailable or there may be a malfunction in the system.
In the following situations, perform the actions specified in the table. When the normal
●
operating conditions are detected, the message will disappear and the system will
become operational.
If the message does not disappear, contact your Lexus dealer.
When the area around a sensor is covered
with dirt, moisture (fogged up, covered with
condensation, ice, etc.), or other foreign
matter
When the temperature around the front
camera is outside of the operational range,
such as when the vehicle is in the sun or in an
extremely cold environment
The area in front of the front camera is
obstructed, such as when the hood is open
or a sticker is attached to the part of the
windshield in front of the front camera.
In the following situations, if the situation has changed (or the vehicle has been driven for
●
LS500h_OM_General_OM50J66E
Situation
Actions
To clean the part of the windshield in front of
the front camera , use the windshield wipers
or the windshield defogger of the air condi-
tioning system (P.408).
If the front camera is hot, such as after the
vehicle had been parked in the sun, use the
air conditioning system to decrease the tem-
perature around the front camera.
If a sunshade was used when the vehicle
was parked, depending on its type, the sun-
light reflected from the surface of the sun-
shade may cause the temperature of the
front camera to become excessively high.
If the front camera is cold, such after the
vehicle is parked in an extremely cold envi-
ronment, use the air conditioning system to
increase the temperature around the front
camera.
Close the hood, remove the sticker, etc. to
clear the obstruction.
Advertisement
Table of Contents
