Table of Contents
Advertisement
364
4-5. Using the driving support systems
Time
C
Hybrid system output restriction control begins operating
D
System determines that possibility of collision with detected object is high
E
Hybrid system output reduced
F
System determines that possibility of collision with detected object is extremely
G
high
Brake control begins operating
H
Brake control strength increased
I
Example: Multi-information display:
J
"BRAKE!"
Example: Multi-information display: "Switch to Brake"
K
If the Parking Support Brake has oper-
■
ated
If the vehicle is stopped due to operation of
the Parking Support Brake, the Parking
Support Brake will be disabled and the
PKSB OFF indicator will illuminate. If the
Parking Support Brake operates unneces-
sarily, brake control can be canceled by
depressing the brake pedal or waiting for
approximately 2 seconds for it to automati-
cally be canceled. Then, the vehicle can be
operated by depressing the accelerator
pedal.
Re-enabling the Parking Support Brake
■
To re-enable the Parking Support Brake
when it has been disabled due to operation
of the Parking Support Brake, either enable
the system again (P.361), or turn the
power switch off and then back to ON
mode.
Additionally, if any of the following condi-
tions are met, the system will be re-enabled
automatically and the PKSB OFF indicator
will turn off:
The P shift position is selected
●
The object is no longer detected in the
●
traveling direction of the vehicle
The traveling direction of the vehicle
●
changes
LS500h_OM_General_OM50J66E
*
*
: Except when the Parking Support Brake
function (rear pedestrians) operated.
If "Parking Support Brake Unavailable"
■
is displayed on the multi-information
display and the PKSB OFF indicator is
flashing
If this message is displayed only when the
●
R shift position is selected, the rear cam-
era lens may be dirty. Clean the camera
lens. If this message is displayed when the
shift position is any position other than R,
a sensor on the front or rear bumper may
be dirty. Clean the sensors and their sur-
rounding area on the bumpers.
Initialization may not have been per-
●
formed after a 12-volt battery terminal
was disconnected and reconnected. Ini-
tialize the system. (P.365)
If this message continues to be displayed
even after initialization, have the vehicle
inspected by your Lexus dealer.
If "Parking Support Brake Unavailable"
■
and "Parking Assist Unavailable Clean
Parking Assist Sensor" are displayed on
the multi-information display and the
PKSB OFF indicator is flashing
A sensor may be covered with ice, snow,
●
dirt, etc. Remove the ice, snow, dirt, etc.,
from the sensor to return the system to
normal. If this message continues to be
displayed even after cleaning the sensor,
Advertisement
Table of Contents
