Automatic Turning - Keyestudio 4DOF Manual

myservo.attach(A0); // modify each pin to adjust
myservo.write(0); // angle value
delay(1000);
}
************************************************************************************************************************************
Test Result:
Stack the drive shield onto UNO R3 board and connect the servo motor, upload well the code. Powered on, press
the reset button, the servo will automatically rotate to 0°.
 Automatic Turning
Description:
In the previous section, you have learned to set the Servo angle. In fact, we just need to continually change the
angle of 4 Servo motors, thus make the 4DOF robot arm operate different motions.
Hookup Guide:
133