Safety Information - Kalor Paola 13 User Manual

1.0 Norms and declarations of conformity
Our company declares that the insert conforms to the following norms for the EC European Directive labelling:
2014/30 UE (regulation EMCD) and following amendments;
2014/35 UE (Low Voltage Directive) and following amendments;
2011/65 EU (RoHS 2 directive);
The Rules of Construction Products (CPR-Construction Products Regulation) No. 305/2011 regarding the construction world;
For installations in Italy, please refer to UNI 10683/98 or following changes. For the water-thermo-sanitary equipment, let the
installer give you the conformity declaration in compliance with L. 37/2008. While installing the unit respect the local, national
and Europen rules;
EN 55014-1; EN 55014-2; EN 61000-3-2; EN 61000-3-3; EN 60335-1; EN 60335-2-102; EN 62233, EN 50581.

1.1 Safety Information

Please carefully read this use and maintenance manual before installing and operating the insert!
If clarification is needed, please contact the dealer or the Authorized Assistance Centre.
• The pellet insert must only be operated in living environments. This insert, being controlled by an electronic board,
permits a completely automatic and controlled combustion; the exchange, in fact, regulates the lighting phase, 5 power
levels and the shut down stage, guaranteeing the safe operation of the insert;
• The basket used for combustion allows most of the ash produced by the combustion of the pellets to fall into the collec-
tion compartment. Nevertheless, check the basket daily, given that not all pellets have high quality standards (use only
quality pellets recommended by the manufacturer);
• The glass is equipped with a special circulation of air for self-cleaning, but still, it is not possible, after several hours of
operation, to keep a light grey patina from forming on the glass. This also depends on the type of pellets used. Some
pellets deposit more ash than others.
1.2 Responsibility
With the delivery of the present manual, we decline all responsibility, both civil and penal, for accidents deriving from the
partial or total lack of observance of the instructions contained herein.
We decline every responsibility derived from improper use of the insert, from incorrect use by the user, from unauthorized
modifications and/or repairs, from the use of replacement parts that are not original for this model.
The manufacturer declines every civil or penal, direct or indirect responsibility due to:
• Lack of maintenance;
• Failure to observe the instructions contained in the manual;
• Use in non-conformity with the safety directives;
• Installation in non-conformity with the norms in force in the country;
• Installation by unqualified or untrained personnel;
• Modifications and repairs not authorized by the manufacturer;
• Use of non-original replacement parts;
• Exceptional events.
• The insert must only be fed with quality 6 mm diameter pellets of the type
• Before making the electrical connection of the insert the discharge tubes
!
• The environment where the insert is installed must have a sufficient ex-
• Never open the door of the insert while it is operating;
• When the insert is operating, the surfaces, glass, handle and tubes beco-
2
recommended by the manufacturer;
must be connected with the flue;
change of air;
me very hot: during operation do not touch these parts without adequate
protection;