Preliminary Checks; Display Information - Kalor Paola 13 User Manual

Preliminary checks

Before switching on the pellet Insert, make sure that the pellet hopper is full, the combustion chamber is clean, the glass door
is closed, the power supply plug is connected and the switch on the back is set to "1."

7.0 Display information

TURNED OFF
21 : 10
The Insert is off.
22°C P-1
TURNED OFF
TURNED ON
14 : 35
The Insert is in the fi rst ignition
21°C P-2
phase. The glow plug and fume
ACCENDE
extractor are active.
LOAD PELLET
14 : 35
In this phase of the ignition process
21°C P-2
the Insert starts loading the pellets
LOAD
into the brazier. The glow plug, the
pellet
fume extractor and the cochlea
engine are active.
FIRE PRESENT
14 : 35
In this phase of the ignition process
22°C P-1
the Insert starts loading the pellets
FIRE
into the brazier. The fume extractor
present
and the cochlea engine are active.
WORK
15 : 18
The Insert is working, in this case
22°C P-3
at power 3. The detected room
WORK
temperature is 21 ° C. During
normal work, the fumes fan, the
auger motor and the room fan are
active.
!
6
ATTENTION!
The insert will function during the hours of ON programming at
the same temperature and the power settings as when it was last
shut down.
BRAZIER CLEANING
15 : 18
The Insert is cleaning the basket.
22°C p-2
The smoke extractor runs at
BRAZIER
maximum speed and the pellet
CLEANING
load is at minimum.
ON STAND BY
21 : 10
All the requests have been
22°C P-1
satisfi ed and the insert is ready for
STAND BY
the "STAND BY" mode.
HOLD REQUEST
14 : 35
The insert is in a "STAND BY"
21°C P-2
mode as everything has been
HOLD
satisfi ed. The insert is waiting for
REQUEST
an heating request to turn on.
WAIT COOLING
14 : 35
The insert has to complete the
21°C P-2
cooling circle before turning on
WAIT
again.
COOLING