Standby Mode; External Thermostat - Kalor Paola 13 User Manual

9.0 Stand-by mode
This mode allows the automatic shutdown of the insert once it reaches the temperature set on SET.
When this happens, the insert will wait a few minutes (factory setting), after which will turn off automatically if the
temperature of the room in the meantime has always maintained above the set.
Once turned off as a result of this condition, the insert will automatically turn on only when the ambient temperature will
drop to 2 °C below the set temperature in the oven (example: SET=24 °C and ambient temperature = 21 °C).
If the insert is turned off for the sleep-mode, although there is an ignition programmed this will be ignored and the heater
will turn back on only to lower the temperature as explained above.
The sleep timer is instead always respected if the insert is in STAND-BY and is turned off manually by pressing the OFF
button; doing so the insert will shut down permanently rekindling not more, less than expected from the ignition weekly
programming.
Enabling stand-by mode
Press the SET (3) to access the menu and with the button
SET (3) to access it; STAND-BY function is set by default to OFF. SET (3) to access it; STAND-BY function is set by default to OFF.
To activate this feature, press
then OFF (4) to leave. The STAND-BY mode is now active.

10.0 External thermostat

The insert has the possibility to interface with an external thermostat to control the ignition and switch off of the insert
according to the room temperature. The thermostat must be of open / closed type with a clean contact.
If the thermostat carries voltage to the card causing faults, the warranty will expire.
To confi gure the thermostat, simply remove the jumper on the Therm clamp and connect the room thermostat
OPERATION BY A SPECIALIZED TECHNICIAN
Once switched on, the insert will remain in operation until the temperature set in the thermostat is reached.
When the contact is opened the insert will remain in modulation and the display will show ECO THERM for 5 minutes,
after which it will go to Stand-by ECO + OFF.
At the moment of a new heat request in the room (and therefore re-closing), the insert will remain in ECO ATT mode for
10 minutes. If during this time the contact remains closed, the insert will switch on.
NOTE:
At the moment when the insert will be switched off manually
the thermostat.
(1), on the display you will see "ST A N‐ BY M OD E O N". Press SET (3) to confi rm and
(5) reach the M EN U 0 5 (ST A N ‐BY M OD E). Then press
or by programming, it will no longer be connected by
13