Safety Devices - Kalor Denia 14 Installer And User Manual

Safety devices

Pressure switch: monitors
depression in the smoke duct.
It is designed to shut down the
pellet feed screw in the event
of an obstructed flue or sig-
nificant back-pressure in the
presence of wind. At the time
of the pressure switch will
show "A L A R - D E P - F AI L".
Electrical safety: the stove is
protected against violent surg-
es of current (ex. lightnings)
by the main fuse 4 A which is
located on the control panel
at the rear of the stove. Other
fuses to protect the electronic
boards are to be found on the
boards themselves.
Tampering with the safety devices is prohibited. It is only after eliminating the cause which gave
rise to the intervention of the safety system, that it is possible to relight the stove and thus reset
the automatic operation of the sensor. To understand which anomaly has occurred, consult this
manual at paragraph relating to alarms which explains what to do based on the alarm message the
stove display.
50
Reduction motor: if the motor
stops, the stove continues to
function until the flame goes
out for lack of fuel, and until It
has cooled down to the mini-
mum level.
RESTART
PELLET
Pellets temperature safety:
In the rare event there is a too
high temperature in the tank,
the thermostat for pellets safe-
ty with manual reset creates an
alarm "A L A R- S I C - F A I L" stop-
ping the pellet boiler stove.
You need to reset the system
working on the device placed
on the back of the stove.
Flue gas temperature sen-
sor: thermocouple that meas-
ures the temperature of the
fumes while keeping the oper-
ation or shuts the stove when
the flue gas temperature drops
below the preset value.
Room thermostat: the room
thermostat detects the pre-
sent temperature in the room.
When it detects the set tem-
perature on the display, the
stove will go into operation in
ECO ie hold function to save
fuel.
The room thermostat should
be spread so as not to be con-
ditioned by the temperature of
the body stove.