Safety Information - Kalor Cloe 17B User Manual

Norms and declarations of conformity
Our company declares that the Hydro Insert conforms
to the following norms for the EC European Directive
labelling:
• 2014/30 UE (regulation
amendments;
• 2014/35 UE (Low Voltage Directive) and following
amendments;
• 2011/65 UE (RoHS 2 directive);
• The New Rules of Construction Products (CPR-
Construction Products Regulation) No. 305/2011
regarding the construction world;
• For installations in Italy, please refer to UNI 10683/98
or following changes. For the water-thermo-sanitary
equipment, let the installer give you the conformity
declaration in compliance with L. 37/2008. While installing
the unit respect the local, national and Europen rules;
• EN 55014-1; EN 55014-2; EN 61000-3-2; EN 61000-3-3;
EN 60335-1; EN 60335-2-102; EN 62233, EN 50581.

Safety information

Please carefully read this use and maintenance manual
before installing and operating the Hydro Insert!
If clarification is needed, please contact the dealer or the
Authorized Assistance Center.
• The pellet Hydro Insert must only be operated in living
environments. This Hydro Insert, being controlled by an
electronic board, permits a completely automatic and
controlled combustion; the exchange, in fact, regulates
the lighting phase, 5 power levels and the shut down
stage, guaranteeing the safe operation of the Hydro
Insert.
• The basket used for combustion allows most of the ash
produced by the combustion of the pellets to fall into
the collection compartment. Nevertheless, check the
basket daily, given that not all pellets have high quality
standards (use only quality pellets recommended by the
manufacturer).
Responsibility
With the delivery of the present manual, we decline all
responsibility, both civil and penal, for accidents deriving
from the partial or total lack of observance of the
instructions contained herein.
We decline every responsibility derived from improper use
of the Hydro Insert, from incorrect use by the user, from
unauthorized modifications and/or repairs, from the use
of replacement parts that are not original for this model.
94
EMCD) and following
The manufacturer declines every civil or penal, direct or
indirect responsibility due to:
• Lack of maintenance;
• Failure to observe the instructions contained in the
manual;
• Use in non-conformity with the safety directives;
• Installation in non-conformity with the norms in force in
the country;
• Installation by unqualified or untrained personnel;
• Modifications and repairs not authorized by the
manufacturer;
• Use of non-original replacement parts;
• Exceptional events.
• Use only wood pellets;
• Keep / store the pellets in a cool
dry place;
•Never pour pellets directly on the
hearth;
• The Hydro Insert must only be fed
with quality 6 mm diameter pellets, A1
certified according to the UNI EN ISO
17225-2 regulations;
• Before making the electrical connection
of the Hydro Insert the discharge tubes
must be connected with the flue;
• The protective grill placed inside the
pellet container must never be removed;
• The environment where the Hydro
Insert is installed must have a sufficient
exchange of air;
• It is forbidden to operate the Hydro
Insert with the door open or the glass
broken;
• Do not use the Hydro Insert as an
incinerator; the Hydro Insert should be
used only for the intended purpose;
• Any other use is considered improper
and therefore dangerous. Do not put in
the hopper other than wood pellets;
• When the Hydro Insert is operating,
the surfaces, glass, handle and tubes
become very hot: during operation do
not touch these parts without adequate
protection;
• Keep the fuel and other inflammable
materials off the Hydro Insert.