Kalor Paola 13 User Manual page 17

11.5 Cleaning the brazier and brazier support
When the flame assumes a red colour or seems weak, and
is accompanied by black smoke, this means that there are
ash deposits or incrustations that do not permit the correct
functioning of the insert and that must be removed. Remove
the brazier every day by simply raising it from its slot (Pict.
13); then clean out the ashes and eventual incrustations that
may have formed, paying particular attention to liberating the
holes by using a pointed tool (not included with the insert).
This operation is made particularly necessary before every
lighting the first several times and above all if using pellets
that differ from those supplied by our company. The frequen-
cy of this operation is determined by how frequently the in-
sert is used and the choice of pellets.
It is suggested to check the brazier support too. Remove it
from its base and clean eventual ash rests with an aspirator
(Pict. 14).
NOTE: when you insert the brazier support, be
sure you install it on the stopping device on the
support brackets (Pict. 15). The brazier flap for
pellets fall (Pict. 16) must be addressed to the
inner part of the combustion chamber.
Pict. 15: how to insert the brazier support
Pict. 13: brazier
Pict. 14: brazier support
Pict. 16: how to insert the brazier
15