Parts Diagrams - Pacific S-20 Parts & Operating Manual

ISSUE
SCRUB HEAD IS STILL RAISED
BATTERYSHIELD® LED IS ILLUMINATED AND HAS
DISABLED THE SCRUB HEAD (IF EQUIPPED)
BATTERIES ARE DISCHARGED BELOW THRESHOLD
VOLTAGE
BRUSH MOTOR CIRCUIT BREAKER HAS TRIPPED
SCRUB HEAD WILL
NOT RUN
SCRUB HEAD LIFT ARM SWITCH MAY BE STUCK OR
FAULTY
TRIGGER SWITCH IN HANDLE MAY BE FAULTY
SOLUTION SOLENOID VALVE MAY HAVE AN INTERNAL
SHORT
BATTERYSHIELD® RELAY MAY BE FAULTY (IF EQUIPPED)
INADEQUATE SOLUTION FOR APPLICATION
SCRUB HEAD IS SET TO HEAVY DOWN PRESSURE
SCRUB HEAD CIRCUIT PAD IS TOO AGGRESSIVE FOR APPLICATION
BREAKER IS TRIPPED
FAULTY OR SHORTED WIRE
WEAK CIRCUIT BREAKER
CIRCUIT BREAKER MAY BE TRIPPED
BATTERY METER IS FLASHING A FAULT CODE
BATTERIES DISCHARGED TOO LOW
MACHINE WILL NOT
DRIVE
SPEED CONTROL KNOB TURNED ALL THE WAY DOWN
FAULTY CONTROLLER
FAULTY WIRING
BATTERIES ARE LOW ON WATER (LEAD ACID ONLY)
CHARGER IS NOT SET PROPERLY FOR BATTERY TYPE
SCRUB HEAD IS IN HEAVY DOWN PRESSURE
RUN TIME IS SHORT
BATTERY CHARGER IS NOT ABLE TO FINISH CHARGE
CYCLE
BATTERIES ARE DEFECTIVE OR AT THE END OF THEIR
LIFE
RETURN TO
TABLE OF
CONTENTS
TROUBLESHOOTING GUIDE
POTENTIAL CAUSE
(PAGE 2 OF 2)
PROPOSED SOLUTION
LOWER SCRUB HEAD
SERVICE THE BATTERIES
CHARGE BATTERIES
SEE NEXT TOPIC ON THIS TABLE
INSPECT AND REPAIR SWITCH AS REQUIRED
INSPECT AND REPAIR AS REQUIRED
DISCONNECT WIRES FROM SOLENOID VALVE AND TRY RUNNING THE SCRUB
HEAD AGAIN. REPLACE SOLENOID IF REQUIRED
CONTACT SERVICE TECHNICIAN TO TROUBLESHOOT AND ISOLATE
INCREASE SOLUTION TO SCRUB HEAD
REDUCE DOWN PRESSURE SETTING
CONTACT YOUR LOCAL DISTRIBUTOR FOR RECOMMENDED APPLICATION
REPAIR
CONTACT SERVICE TECHNICIAN TO TROUBLESHOOT AND ISOLATE.
BREAKER SHOULD NOT TRIP BELOW ITS STATED RATING
INSPECT AND RESET. IF PROBLEM PERSISTS CONTACT SERVICE TECHNICIAN
REFERENCE FAULT CODE AND TROUBLESHOOT AS REQUIRED
CHARGE BATTERIES
INCREASE SPEED SETTING
CONTACT SERVICE TECHNICIAN TO TROUBLESHOOT AND ISOLATE
CONTACT SERVICE TECHNICIAN TO TROUBLESHOOT AND ISOLATE
SERVICE BATTERIES
SET CHARGER TO BATTERY SPECIFICATIONS
REDUCE SCRUB HEAD PRESSURE
CONFIRM A STEADY GREEN LED AFTER THE CHARGE CYCLE (BEFORE
UNPLUGGING FROM THE OUTLET)
CONTACT SERVICE TECHNICIAN TO TROUBLESHOOT AND ISOLATE
MANUAL SECTION
SCRUB DECK SETUP
BATTERIES
CHARGING
TROUBLESHOOTING TABLE

PARTS DIAGRAMS

PARTS DIAGRAMS
WIRING DIAGRAM
WIRING DIAGRAM
PRE-USE SETUP
PRE-USE SETUP
PRE-USE SETUP
WIRING DIAGRAM
PARTS DIAGRAMS
PRE-USE SETUP
PRE-USE SETUP
CHARGING
DRIVE SYSTEM
WIRING DIAGRAM
WIRING DIAGRAM
BATTERIES
CHARGING
PRE-USE SETUP
CHARGING
BATTERIES