Pacific S-20 Parts & Operating Manual page 20

DISK MACHINE PAD DRIVERS & BRUSHES
PAD & BRUSH REMOVAL
NOTE: Using a pad driver without a pad will damage the floor surface.
1. Toggle the "Brush On/Off" switch to position "A" for 1 second and then immediately to position "B". The
brush will spin in position "A" and abruptly stop in position "B", releasing the pad drivers.
2. Remove the center lock fitting by squeezing the wires inward and pulling the center lock away.
3. To connect the cleaning pad to the drivers, center the pad on the driver, squeeze the center lock wires
inward, and press down (tab side first). Press the pad and release the wires so that they lock in place.
PAD & BRUSH INSTALLATION
1. Turn the key switch on and rotate the speed control knob to the full slow position.
2. Place the pad drivers or brushes on the floor in front of the scrub head.
3. Push or drive the machine into position centering the scrub head over the pad drivers or brushes.
4. Lower the scrub deck onto the pad drivers or brushes.
NOTE: When properly aligned, the scrub deck shroud bristle skirt should almost be touching the floor.
5. Quickly pulse and release the activation trigger to "CLICK ON" the pad drivers or brushes.
NOTE: If the pad drivers or brushes do not quickly engage, return to step two and try again.
RETURN TO
TABLE OF
CONTENTS
19