Orbital Pads & Chemical Free Finish Removal - Pacific S-20 Parts & Operating Manual

ORBITAL PADS & CHEMICAL-FREE FINISH REMOVAL (CFR)
NOTE: Do not lower the orbital head without a pad installed. Doing so may damage the Mighty-Lok
STANDARD CLEANING OPERATIONS
1. Align the corners of the pad to the corners of the aluminum plate and press to attach.
2. Lower the scrub deck onto the pad.
3. Ensure the pad is properly aligned front-to-back and left-to-right.
CHEMICAL-FREE FINISH REMOVAL (CFR) PAD ASSEMBLY
A specialized surface preparation pad, in addition to the traditional cleaning pad, is required for chemical-free
finish removal. The traditional pad acts as a "backer pad" and compensates for variances in the floor.
1. Place the black retainer pad 2" back from the front of the red
scrub pad and the maroon CFR pad to allow water saturation.
2. Align and assemble the pads with the red pad on top and the
maroon pad on the bottom facing the floor.
3. Ensure the gap mentioned in step 1 is facing forward and refer
to steps 1-3 of "Standard Cleaning Operations" above to
install the CFR Pad Assembly.
MACHINE SETUP
1. Install the CFR Pad Assembly as described above.
2. Fill the solution tank with clean water.
3. Set the down pressure to Heavy (see "Selecting Down Pressure" above).
4. Set the solution flow to midrange. Adjust as needed for maximum finish removal, using the least amount of
water needed for effective rinsing.
5. Adjust the machine speed as required.
RETURN TO
TABLE OF
CONTENTS
18
face.
®