Pacific S-20 Parts & Operating Manual page 10

BATTERYSHIELD
Scrubbers equipped with BatteryShield® technology have a sensor on the battery pack and a red LED indicator
on the control panel which monitor and communicate low water conditions.
1. When batteries are fully charged and the key is turned on, BatteryShield
• If the LED remains off, there is sufficient water in the batteries.
• A solid red LED means BatteryShield
disabled to prevent battery damage.
• A blinking red LED means the BatteryShield
NOTE: Failure to clean the HydroLink
and will reduce battery life.
2. Turn the key off and use the HydroLink
NOTE: Battery packs equipped with BatteryShield
BatteryShield
longer compress may result in uneven battery servicing and premature battery failure.
3. After completing the HydroLink
RETURN TO
TABLE OF
CONTENTS
AUTOMATED WET BATTERY PROTECTION
®
light pipe will limit the BatteryShield's
®
®
LED has illuminated. Failure to pump the HydroLink
®
watering procedure, cycle the key to verify the LED stays off.
®
SYSTEM
senses a low-water level. The brush motor will be
®
light pipe needs to be cleaned (see below).
®
single-point battery watering system to fill the batteries.
may take more than 1/2 gallon of water
®
9
will check the water level.
®
ability to read the water level
®
after the
bulb until it will no
™