Related Manuals for Pacific Tsunami
Summary of Contents for Pacific Tsunami
- Page 1 Tsunami / High Flow Extractor Operations & Maintenance Operations & Maintenance Operations & Maintenance Operations & Maintenance Operations & Maintenance PFM/MEM/1102 Pacific Floor Machine Co.
- Page 2 Tsunami Carpet Extractor Setup and Operations Tsunami Carpet Extractor Setup and Operations Tsunami Carpet Extractor Setup and Operations Tsunami Carpet Extractor Setup and Operations Tsunami Carpet Extractor Setup and Operations Setting the Chemical Dilution Ratio on the Mac Setting the Chemical Dilution Ratio on the Mac...
- Page 3 Operations Read and understand the Operators Manual that came with the machine. If this manual is not on hand it may be ordered from your local Pacific dealer or by calling Pacific directly at 800-968-1332 and speaking with a customer care representative.
- Page 4 Assemb Assemble the Needed Assemb le the Needed ools ools Tsunami with Hoses and Chemicals Tsunami with Hoses and Chemicals Tsunami with Hoses and Chemicals Tsunami with Hoses and Chemicals Tsunami with Hoses and Chemicals Traffic Lane Extraction Cleaner goes into this bottle and is metered into the yellow pre-treat hose and wand.
- Page 5 IN and the clear hose is for dirty water OUT. Plug the electrical cable into the pig tail on the machine. Gray line water IN Turn valves to Electrical Plug Open position Clear line dirty water OUT Pacific Floor Machine Co. Page 4...
- Page 6 This al- lows defoam liquid to be pulled into the re- covery tank. If the carpet seems to be clear of cleaner residual, you may pretreat the area as needed. Pacific Floor Machine Co. Page 5...
- Page 7 Extra hoses are available in 50’ sections with valves on each end. The maximum workable hose length is 250 feet. If more distance is needed, an extra externally mounted discharge pump may be used. Pacific Floor Machine Co. Page 6...
- Page 8 Use the spray wand to clean the float mechanism and pump filters. Remove the pump filter screens for a complete cleaning. Unscrew the brass thumb nut to remove the float for a more com- plete cleaning. Pacific Floor Machine Co. Page 7...
- Page 9 The see through channel cover should be removed for cleaning on a regular basis. Use a wet pick up vacuum to remove residual sand and water. Pacific Floor Machine Co. Page 8...
- Page 10 2 gaskets instead of 1 gives longer and more trouble free impeller life. Remove the impeller and wipe clean the running surfaces inside the pump hous- ing. Coat the new impeller and running surfaces with a bit of vegetable oil. Pacific Floor Machine Co. Page 9...
- Page 11 Install the pump cover plate and secure with the 4 mounting screws. Reinstall the machine cowling and secure with the 2 mounting screws. Do an assurance test on the pump before sending the unit back into the service. Pacific Floor Machine Co. Page 10...
- Page 12 1. Short in unit or cable 1. Stop using & Service CK 11. Defoamer not injecting 1. Clogged tube 1. Clean tube 2. Faulty switch 2. Service CK & replace 3. Faulty solenoid 3. Service CK & replace Pacific Floor Machine Co. Page 11...