Application; Operating Conditions - PERCo ST-01 Assembly And Operation Manual

Thank you for purchasing PERCo product. Please follow instructions given in this Manual
carefully and this high-quality product will provide many years of trouble-free use.
Assembly and Operation Manual for the ST-01 Speed gate and STD-01 Double-sided section
(hereinafter – the Manual) contains the instructions on safe transportation, storage, installation,
operation and maintenance of the above-mentioned products. The installation must be carried out
by qualified installers in strict accordance with the Manual.
Abbreviations adopted in the Manual:
ACS – access control system;
CLB – control logic board;
PS – power supply;
RC-panel – remote control panel;
WRC – wireless remote control;
Due to continuous improvement of products, the Manufacturer reserves the right to modify, without
previous notice, the product design not aggravating its technical specifications.

1 APPLICATION

ST-01 Speed gate (hereinafter – the speed gate) is designed for pedestrian passage control at
entrance points of administrative buildings, banks, shops, railway terminals, airports, etc.
Attention!
ST-01 speed gate is designed for the passage of pedestrians taller than 1 m,
otherwise correct operation of the speed gate is not guaranteed. Pass through the
speed gate of children less than 1 m height tall can only be carried by the arm
accompanied by adults
The speed gate features two sections: ST-01/M (hereinafter – Master section) and ST-01/S section
(hereinafter – Slave section). In a standard delivery set the speed gate allows to arrange one
passage lane. The width of the passage lane depends on the chosen swing panel width.
Use STD-01 double-sided section (hereinafter – double-sided section) to arrange more passage
lanes. Each double-sided section provides one extra passage lane.
Note:
Inside the turnstile sections, it is possible to install access card readers as manufactured by
PERCo (IR03.1, MR07 OEM, RP-15.2), and by third-party manufacturers. The selection of
the reader, its purchase and installation into the product are carried out by the customer
(installer) in accordance with the checkpoint design and the ACS and controller
characteristics. Card readers are not included in the standard delivery set of the turnstile!
Readers must meet the following requirements:
Overall dimension (length × width × height) .................................... max. 155×68×28 mm
Read range ..................................................................................................... min. 40 mm

2 OPERATING CONDITIONS

The product with regard to resistance to environmental exposure complies with GOST15150-69
category NF4 (operation in premises with climate control).
Operation of the speed gate is allowed at an ambient air temperature from +1°C to +50°C and
relative air humidity 80% at +25°C.
1
If the turnstile is installed in children's institutions or in organizations working with children, where more
secure passage mode is required, it is recommended to reflash turnstile controller with a special firmware
(ST01_Children). Its main feature is the safety zone increased to the whole passage zone of the turnstile
and particular operation algorithm when swing panels do not close if at least one sensor of the turnstile is
active.
In order to get necessary recommendations regarding the firmware installation, please contact PERCo
technical support team.
ST-01 Speed gate, STD-01 Double-sided section
Dear Customer!
1
.
3