Operating Devices; Rc-Panel Connection - PERCo ST-01 Assembly And Operation Manual

9. After the passage is completed and the swing panels are closed, the speed gate is ready for
another passage.
In potential speed gate control mode, the control signal can be released after receiving a signal
from PASS output for the same direction.

5.3 Operating devices

Speed gate operation can be performed through the following devices: RC-panel / WRC; ACS-
controller, Fire Alarm device. These devices can be connected to the speed gate separately,
simultaneously or in any combination with each other.
In case several operating devices are connected simultaneously there can be a control signal
overlap. In this case speed gate will operate according to the command, generated by the signal
combination (Appendixes 1 and 2).

5.3.1 RC-panel connection

RC-panel is connected with a flexible multicore cable to Unlock A, Stop, Unlock B, Led A,
Led Stop, Led B, Sound and GND contacts of the X2 terminal block according to the speed gate
connection layout (Fig. 18).
Figure 12. Standard RC-panel orientation regarding speed gate sections
Note:
WRC is connected to Unlock A, Stop, Unlock B and GND contacts of the X2 terminal block.
Power supply of the WRC is connected to +12V contact of the X3 terminal block.
Standard RC-panel orientation regarding sections is stated in Fig. 12. If the operator's workspace
is located on the opposite side regarding Master section, it will be more convenient to change the
RC-panel wires, which are connected to Unlock A and Unlock B contacts, as well as Led A and
Led B respectively (Table 4).
Table 4. Connection of RC-panel cable wires to the X2 connector block
№
1
2
3
4
5
6
7
8
Contact
GND
Unlock A
Stop
Unlock B
Led A
Led Stop
Led B
Sound
ST-01 Speed gate, STD-01 Double-sided section
RC-panel orientation
Standard
black
white
blue
green
yellow
orange
red
brown
Reverse
black
green
blue
white
red
orange
yellow
brown
19