Indication Blocks; Rc-Panel - PERCo ST-01 Assembly And Operation Manual

The glass section top cover (STC-01G, SDC-01G, STC-01GS, SDC-01GS) features an indication
block (blocks) (11), that consists of passage granting indicator (green arrow) and access card
presentation zone indicator ("hand with a card" pictogram).
The bottom part of the Master section central post features ST-01.771 speed gate control board
(hereinafter – control board). The PS, the RC-panel (WRC receiver), Fire Alarm device and Slave
section connection cables are connected to the control board.

5.2.2 Indication blocks

Each section features the following indication blocks:

Top cover (STC-01G, SDC-01G, STC-01GS, SDC-01GS) indication block (11) includes a
white indicator (a hand with a card), indicating the card presentation zone and a green
indicator (an arrow), which lights up in case the passage in this direction is granted:

Central post indication block (3) is designed for passage grant (green light) / denial (red
light) indication for each direction.

Front end indication block (9) is designed for indicating passage direction through the speed
gate. It displays the constant indication (white arrow or red cross):
The type of indication of the front-end block can be chosen during the installation of the
speed gate by connecting the front-end cable to the corresponding indication control
module connector (located under the speed gate cover on the protection plate, Fig. 20). By
default, the cable is connected to the ARROW connector, the area where white arrow
points at. To access the speed gate indication control module, the section top cover is to be
removed (10) (see Sect. 8.9.6).

5.2.3 RC-panel

RC-panel (17) is a small table device made of shockproof ABS plastic. RC-panel is designed for
speed gate operation in the manual mode, in which the operator sends commands to the
equipment. The overall view of the RC-panel is shown in Fig. 8.
RC-panel housing features three control buttons for sending commands. The middle STOP button
serves for setting the "Always locked" mode. The LEFT and RIGHT buttons serve to open the
passage in the chosen direction. Up above the buttons there are LED lights, indicating passage
direction status. The red "Stop" indicator shows the "Always locked" operating mode. The possible
operation commands and RC-panel indication for pulse and potential operating modes are stated
in Tables 7 and 8.
– green indicator of passage granting
– white indicator of card presentation zone
– red indicator of passage denial
– white indicator of the passage direction
ST-01 Speed gate, STD-01 Double-sided section
13