Swing Panel Cover Plate - PERCo ST-01 Assembly And Operation Manual

Assembly and Operation Manual

8.9.4 Swing panel cover plate

Swing panel cover plate (4) consists of two parts. In order to install the cover plate, proceed as
follows:
1. Turn fully the rotating support of swing panel in the clockwise direction.
2. Assemble one of the cover plate components on the rotating support. In order to do that,
mount the cover plate on the upper plate of the rotating support through the slots in the upper
part of the cover plate. After that, shift the cover plate down to the end, mounting the bottom
cover plate mortise into a tenon, located in the bottom part of the rotating support (Fig. 21).
3. Fix the installed part of the cover plate with a Philips screwdriver to the rotating support with
two M4×10 screws with washers from the delivery set.
4. Turn fully the rotating support of swing panel in the counterclockwise direction. Mount the
second part of the cover plate likewise.
5. Check the gaps between swing panel and its cover plates, between swing panel cover plates
and central post cover plate, if needed, loosen the M4×10 screws and adjust the bottom part
of the panel cover plate. Tighten the screws.
Panel cover plate removal is performed in a reverse order. Prior to removal, disassemble of central
post indication block is required (see Sect. 8.9.5).
34
Figure 21. Swing panel and its cover plate