Front Panel Of The Side Post; Swing Panel - PERCo ST-01 Assembly And Operation Manual

ST-01 Speed gate, STD-01 Double-sided section

8.9.2 Front panel of the side post

Remove the side post front panel (8), moving it up along the post and then pull it, bringing the
hooks from slots in the side post (Fig. 20). Be careful not to damage the connection cable!
Disconnect the connection cable output from the front-end indication block.
Side post front panel assembly is to be installed in the reverse order.
Prior to mounting (removing) the side post panel, section top cover (10) is to be removed first (see
Sect. 8.9.6).
Figure 20. Side post front panel disassembly
(the dashed line shows the location of the reader)

8.9.3 Swing panel

Two people shall install and remove the swing panels. The swing panel is fixed to the rotating
support in three places with M10×30 bolts, 10 washers, plastic bushing and M10 screws (Fig. 21).
Use S17 open end wrenches.
33