Table of Contents
Advertisement
4.3.2
Line Parameters
NOTE
The dispense gaps for both lines and dots are set in the Dot Parameters window. The
line dispense gaps are the same as the dot dispense gaps of the same number. The
Valve Tilt tab is only available in the Dot Parameters window (Figure 4-1).
To edit line parameters:
1.
In the Fluidmove Main Window, select Teach a Program.
The Programming Window opens.
2.
Select Edit > Line Parameters from the drop-down menu.
The Line Parameters window opens (Figure 4-2).
3.
Notice that the Dispense Gap column is grayed out. The values correspond with those set
in the Dot Parameters window.
The Dispense Gap for Line Type 1 equals the Dispense Gap for Dot Type 1; the
Dispense Gap for Line Type 2 equals the Dispense Gap for Dot Type 2, etc.
Click on OK to close the window.
4.
Operation
Figure 4-2 Line Parameters
13
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Spectrum Series and is the answer not in the manual?
Questions and answers