Installation guide
PS01-48x360F-EX-E-FC (0150-1300)
Phase1+ / Phase1-
Phase2+ / Phase2-
5V / GND
Sensor Sine / GND
Sensor Cosine / GND
Temp. Sensor / GND
Phase / GND
All Pin / Shield
Kty 1
Kty 2
7 Storage, transport, installation altitude
7 Lagerung, Transport, Aufstellhöhe
Sliders are to be stored and transported only in the plastic containers (with cardboard inlay)
provided for this purpose, or already installed and secured in LinMot P stators.
Remove the slider from this plastic containers only for assembling.
The storage area must be dry, dust-free, frost-free and vibration-free.
The relative air humidity should be less than 60 %.
Prescribed storage temperature: -15 °C...70 °C
The motor must be protected against extreme weather conditions.
The air in the storage area must not contain any harmful gases.
The max. installation altitude is 4'000 m above sea level.
From 1'000 m, derating of 1 °C per 100 m is to be considered for air cooling.
LinMot Statoren und Läufer dürfen ausschliesslich in der Orginalverpackung transportiert
und gelagert werden.
Läufer erst beim Einbau aus der Verpackung entnehmen!
Der Lagerraum muss trocken, staubfrei, frostfrei und erschütterungsfrei sein.
Die relative Luftfeuchte sollte weniger als 60 % betragen.
Vorgeschriebene Lagertemperatur: -15 °C...70 °C
Der Motor muss vor extremen Witterungen geschützt werden.
Die Raumluft darf keine aggressiven Gase enthalten.
Die maximale Aufstellhöhe beträgt 4'000 m ü. M.
Ab 1'000 m ist bei Luftkühlung ein Derating von 1 °C pro 100 m zu berücksichtigen.
NTI AG / LinMot
Red / Pink
Rot / Rosa
Blue / Grey
Blau / Grau
White / Inner shield
Weiss / Innerer Schirm
Yellow / Inner shield
Gelb / Innerer Schirm
Green / Inner shield
Grün / Innerer Schirm
Black / Inner shield
Schwarz / Innerer Schirm
-
-
-
-
®
www.LinMot.com
1.5
Pin A / Pin B
1.5
Pin C / Pin D
155
Pin 1 / Pin 2
Pin 3 / Pin 2
33 k
Pin 4 / Pin 2
33 k
Pin 5 / Pin 2
10 k
Pin 1 - 4 / Pin 2
> 20 M
Pin A - 10 / Housing
> 20 M
580 @ 20 °C
Pin 7, 8
580 @ 20 °C
Pin 9, 10
39 / 48