Table of Contents
Advertisement
Option "Boot
The following submenu appears when you select the option "Boot Sequence"
Sequence"
in the main menu:
Figure 5-6 Submenu "Boot Options"
Boot sequence
Setup prompt
POST errors
Floppy check
Summary screen
PG 760 Programming Device
C79000-G7076-C761-01
PhoenixBIOS Setup-Copyright 1985-95 Phoenix Technologies Ltd.
Main
Advanced
Security
Boot Options
Boot sequence:
[A: then C:]
Setup prompt:
[Enabled]
POST errors:
[Enabled]
Floppy check:
[Enabled]
Summary screen:
[Enabled]
F1
Help
Select Item
+ / –
ESC
Exit
Select Menu
Enter Select
Here you can define the device sequence from which a system start
(boot attempt) is to be carried out first.
A: then C:
C: then A:
C: only
During the system loading phase, a SETUP prompt is output at the
bottom of the screen.
The loading procedure is aborted if an error is detected during the
system loading phase.
During the system loading phase, the floppy head is moved by a
number of steppings to the inside, and then returned again. This
test is useful because the drive is initialized again in the process.
The most important system parameters are output on the display at
the end of the system loading phase.
Configuring the PG 760
Power
Exit
Item Specific Help
Order system searches drives
for a boot disk.
Change Values
F9
Setup Defaults
Sub-Menu
F10
Previous Values
First from floppy A: then from drive C:
First from drive C: then from floppy A:
Only from drive C:
5
5-11
Advertisement
Table of Contents
