Table of Contents
Advertisement
Connecting the
You can connect the PG 760 to a SIMATIC S5 programmable controller via
PG 760 to S5
the COM1/TTY interface port. The cable for establishing the connection to
Programmable
the SIMATIC S5 CPUs is included with the PG 760.
Controllers
(Order No. 6ES5734-2BD20)
Figure 3-7
Connecting to the S5 Programmable Controller
Connect your PG 760 to a SIMATIC S5 programmable controller as follows:
1. Switch off the PG 760.
2. Plug the cable into the COM1/V.24 PLC interface port.
Caution
!
Risk of damage to the PG 760!
The interface port may be damaged if you confuse the connections or use the
wrong connecting cables. Make sure the TTY cable of the PG 760 is plugged
into the COM1/TTY port and not into the LPT1 port.
Before plugging in the cables, you must discharge your body's electrostatic
charge by briefly touching a grounded object (ESD guideline).
Use only the original cables to establish the connection to the programmable
controller.
The PG 760 and the programmable controller must be operated at the same
protective ground potential.
PG 760 Programming Device
C79000-G7076-C761-01
Installing and Operating the PG 760
COM1
3
3-11
Advertisement
Table of Contents
