Multipoint Interface (Mpi/Dp) - Siemens SIMATIC PG 760 Manual

3.5

Multipoint Interface (MPI/DP)

Connecting an S7
You can connect your PG 760 to a SIMATIC S7 programmable logic
Programmable
controller using the floating MPI/DP interface. The MPI cable (5 m long) for
Controller via the
connection to SIMATIC S7 CPUs is supplied with the PG 760.
MPI/DP Interface
(Order No.: 6ES7901-0BF00-0AA0)
Figure 3-8
Connect your PG 760 to a SIMATIC S7 programmable controller as follows:
1. Switch off the PG 760.
2. Plug the connecting cable into the MPI/DP port.
Caution
!
Risk of damage to the PG 760!
Before plugging in the cables, you must discharge your body's electrostatic
charge by briefly touching a grounded object (ESD guideline).
Coupling Via the MPI/DP interface, you can couple your programming devices to
The supplied MPI cable can be used for connection to MPI networks with
transmission rates up to 187.5 Kbps.
PG 760 Programming Device
C79000-G7076-C761-01
MPI/DP interface
Connection via Multipoint Interface
MPI networks (S7-200, S7-300 and S7-400) or
PROFIBUS DP networks (DP components).
Installing and Operating the PG 760
6ES7901-0BF00-0AA0
MPI connecting cable
3
3-13