Table of Contents
Advertisement
Connecting a
You can connect a serial mouse to the COM2 serial port. To operate a serial
Serial Mouse
mouse, the appropriate mouse driver must be initialized and assigned
parameters. You will find the information you need to do this in the
description of your mouse or in the description of the operating system.
Proceed as follows:
1. Switch off your PG 760.
2. Plug the serial mouse into the mouse connector labeled COM2.
3. Switch on your PG 760 again.
Recommended
You can connect external multisynchronous monitors using the standard
Monitors
VGA connector on the rear panel of the unit. We recommend that you use
Siemens monitors.
Connecting
You must switch off the PG 760 before connecting the monitor cable. You
Monitors
will find further information about the connector pinout in Chapter 7.
Figure 3-3
Connection to Monitor
Connect the monitor as follows:
1. Switch off the PG 760 and the monitor.
2. Plug the monitor cable into the VGA socket.
3. Plug the other end of the monitor cable into the monitor.
The VGA interface on the basic module permits a resolution up to 1024 x
768 with 256 colors and an image refresh rate of max. 75 Hz.
PG 760 Programming Device
C79000-G7076-C761-01
VGA socket for monitor
Installing and Operating the PG 760
3
3-5
Advertisement
Table of Contents
