Siemens SIMATIC PG 760 Manual page 24

Connecting the Proceed as follows:
Power Cable
1. Check that the correct voltage has been selected.
2. Plug the supplied power cable into the power supply connector.
3. Connect the unit to a socket outlet with a grounded protective conductor.
4. Plug the power supply cable for the monitor into the power supply
Note
Please note that the power supply connector must be unplugged to
completely isolate the unit from the mains supply.
Note
For operation in Canada and the US, a CSA or UL listed power supply cable
must be used.
The computer is intended for operation with grounded power supply
networks (TN networks according to VDE 0100 part 300 or IEC 364-3).
The unit is not intended for operation with non-grounded or
impedance-grounded systems (IT networks).
Use a power cable consisting of at least an AWG cable with a 15 A, 250 V
grounded plug. The cable must fulfil the necessary safety requirements in the
appropriate country.
PG 760 Programming Device
C79000-G7076-C761-01
connector socket.
Installing and Operating the PG 760
3
3-3