Display Parameter Setup; Setting Month/Date/Year/Hour/Minute - VWR AccuSterilizer 1130 Series Operation Manual

Display Parameter Setup

Note
Sterilemax sterilizers are
shipped with the display
units set as follows:
120 volt units - °C, PSI
100 volt units - °C, KPA
240 V~ - °C, BAR
If your unit is not set to these
factory settings or if you
require other settings, refer
to "Changing Temperature
Units" and "Changing
Pressure Units" to set the
units to your requirements.
Note
If you desire to change the
temperature units, press the
up arrow to select "Yes",
then refer to "Changing
Temperature Units."
Setting Month/Date/Year/Hour/
Minute
To set the current date and time:
1. From the "Select Cycle" screen, press the
"Select" key and then the up arrow key.
2. Wait for the sterilizer to display the
"Change Time" Screen. Press the up
arrow key to select "Yes."
3. At the "Set Current Month" screen, press
the up or down arrow key to set the
current month. Press the "Start" key when
the current month is set.
4. At the "Set Current Date" screen, press
the up or down arrow key to set the
current date. Press the "Start" key when
the current date is set.
5. At the "Set Current Year" screen, press
the up or down arrow key to set the
current year's final two digits. Press the
"Start" key when the current year is set.
6. At the "Change Hour" screen, press the
up or down arrow key to set the current
twenty-four hour clock hour. Press the
"Start" key when the current hour is set.
7. At the "Change Minute" screen, press the
up or down arrow key to set the current
minute. Press the "Start" key when the
current minute is set.
8. At the "Change Temperature Units"
screen, press the down arrow key to
select "No."
19