Advertisement
Photo Imager
System Set-Up
The Photo Imager is easy to set up. No tools are required.
Hood Enclosure
Digital Color Camera
Ethidium Bromide Filter
Transilluminator
Color Printer
Combination Lock
CAUTION: Do not install the system in places with high moisture, dust or high temperature. Do not use any
oil or petroleum based cleaner for the cabinet. Use only mild soap or detergent solution for cleaning. Ensure
that the system is turned OFF during cleaning. Keep the equipment away from motors or other large
magnetic equipment apparatus.
Place the Hood on top of the Transilluminator
The hood enclosure is used with a transilluminator. Additional instructions for the transilluminator are
supplied in a separate manual.
CAUTION: All transilluminators are powerful sources of UV radiation that will cause damage to unprotected
eyes and skin. Before operating any unit, be sure all personnel in the area are properly protected. UV
Blocking Eyewear should be worn as well. Refer to Replacement Parts/Accessories for UV Blocking
Eyewear.
1.
Remove the UV blocking clear cover from the
transilluminator if it has previously been
assembled. The UV blocking cover is
recommended for use when operating the
transilluminator out of the hood.
2.
Connect the power cord to the back of the
transilluminator and to a power source. The
transilluminator switch is on the front of the
unit.
3.
Place the Photo Imager's hood on top of the
transilluminator.
Ethidium Bromide Filter Installation
The Ethidium Bromide filter is installed inside the hood enclosure at the UVP factory. To replace the filter,
turn the hood upside down, loosen screws and slide the filter into the filter tray. Retighten screws and place
the hood upright.
Photo Imager
4
Advertisement
