Adding A Device To Mydevices; Adding A Cue To A Script Or Library - Christie ACT User Manual

Section 3: Operation

3.9.4 Adding a Device to MyDevices

1. Select the Editor: My Devices tab.
2. Click Add Device.
3. In the Add Device dialog, type the
Device Name then click the Device
Type button. From the drop-down list,
select a device type and click OK.
4. In the Add Device dialog, click OK.
The new device name appears in the
My Devices list.
5. Click Save. The subroutine appears in
the Editor: My Devices tab.

3.9.5 Adding a Cue to a Script or Library

1. Select the Editor: Script tab or the Editor: Script tab.
2. Click the Add Cue button to open the Select a new Cue drop-down list.
3. Select a new cue. All of the selections displayed in the Select a new Cue drop-down list require you to
make selections or type entries. Each option is outlined in Table 3.16.
show. Saving a script resets Christie ACT's script management engine. If Christie ACT is in the middle of running a script and
another script is saved, the current active script will be interrupted.
Pre-configured device cues.
Table 3.16 Adding Script Cues
Adding Script Cues - Options and Commands
Button
1. Highlight the button number from the drop-down list
(numbered 1-8) and click OK.
2. Highlight the state from the State drop-down list (Click,
Hold) and click OK.
3-28
Figure 3-27 Adding a Device in the Editor: My Devices Tab
Figure 3-29 Add a Cue to a Script
Warning! DO NOT save a script during a
Christie ACT User Manual
020-100129-05 Rev. 1 (02-2010)